Comfort Controls and Audio Systems
Tone Select:
Press “TONE SELECT” to
choose preset treble and bass equalization
settings designed for “ROCK,” “NEWS,”
“POP,” “JAZZ” and “CLASSICAL.”
“ROCK” will appear when you first press
“TONE SELECT.” Each time you press
it, another setting will appear
on
the
display. Press
it
after “CLASSICAL” and
tone control will be back to the treble and
bass knobs.
Adjusting the Speakers
Fade:
Turn the “FADE” knob to move the
sound between the front and rear
speakers.
Balance:
Turn the
“BAL”
control behind
the “FADE’ knob to move the sound
between the right and left speakers.
Recall
Press “RCLVA” to see the station being
played for a moment. Or, press it if you
want to see the time when the ignition is
off.
To
Play a Cassette Tape
Your tape player is built
to
work best with
tapes that are
30
to
45
minutes long
on
:ach side. Tapes longer than that are
so
:hin they may not work well in this player.
The longer side with the tape visible
;hould face to the right. If you hear
lothing or hear just a garbled sound, it
nay not be in squarely. Press “STOP’ or
‘EJECT” to remove the tape and start
mer.
Once the tape is playing, use
the
knobs
For volume, fade and balance, just as you
io
for radio. The lighted arrows show
which side of the tape is playing.
Metal Tapes:
Your bias is set
automatically. When a metal or chrome
tape is inserted, “MTL” will appear on the
display.
Fast Forward:
Press “FF” to advance
rapidly to another part of the tape. Press
“FF,” “RCLVA” or “STOP’ to return to
playing speed.
Rewind:
Press “REW’ to reverse the tape
rapidly. Press “REW,” “RCL~A” or
“STOP’ to return to playing speed.
Next Selection:
Press “NXT” to go
forward to the beginning of the next
selection. Press “NXT” again or press
“RCL
vA’’
or
“STOP”
to cancel this
function.
Previous Selection:
Press “PRV”
to
go
lack to the beginning
of
the selection.
?rem “PRV” again or press “RCL
VA”
or
‘STOP’ to cancel this function.
Por “NXT” and “PRV” to work properly,
your tape must have at least three or four
seconds of silence between each
selection.
Repeat:
Press
“RPT”
to go to the
beginning of the selection and play
it
3gain. Press “RPT” again to cancel this
Function.
Noise Reduction:
Press
00
to remove
noise from Dolby@
B
NR-encoded tapes.
Dolby@
B
Noise Reduction manufactured
under license from Dolby Laboratories
Licensing Corporation.
“Dolbya7’ and the
00
symbol are
trademarks of Dolby Laboratories
Licensing Corporation.
Radio Monitor:
When playing a tape,
press “RDM” during
“FF”
or“REW’ to
hear
the
radio. Press “RDM’ again to turn
the
radio
off.
During “RDM’ operation,
only “TUNE,” “SEEK’ and “PSCAN’
will work.
Tape Sides:
Press “RCL
VA”
to switch
from one side of the tape to the other.
...
94
To Next Page
Loading...
