Need help?Do you have a question about the GEORGE FISCHER +GF+ SIGNET 2550 and is the answer not in the manual?
General| Brand | GEORGE FISCHER |
|---|---|
| Model | +GF+ SIGNET 2550 |
| Category | Accessories |
| Language | English |
Explains the +GF+ SIGNET 2550 Insertion Magmeter's technology, principles, and features.
Guides on selecting an appropriate location for sensor installation to ensure optimal flow profile.
Details on preparing the pipe, including cutting the opening and deburring for fitting the sensor.
Step-by-step instructions for installing the sensor using the specific installation tool.
Procedure for installing the sensor when the dedicated installation tool is not available.
Explains the wiring process for power input, analog output, and frequency output connections.
Details necessary grounding procedures to ensure proper performance and reduce electrical noise.
Provides practical advice for installation, including filter settings and cable routing for water intrusion prevention.
Describes the control panel buttons, digital display, and status indicator lamps for operating the magmeter.
Outlines the menu structure and navigation for accessing various function categories.
Explains how to enter the access code to enable editing of menu settings and calibration parameters.
Introduces functions for calibrating the magmeter, including unit, pipe ID, and current output settings.
Details the process of selecting engineering units for the flow rate display from available options.
Guides on entering the precise interior diameter of the pipe for accurate flow measurement calibration.
Explains how to configure low current, high current, and span for the analog output signal.
Covers functions to tailor magmeter signals, including sensitivity, response time, and noise filters.
Explains how to adjust sensitivity to limit reference noise and stabilize flow readings.
Details how to set response time to manage turbulence and noise effects on output signals.
Describes how to compensate for fluid viscosity to maintain accurate flow measurement.
Explains selecting the AC noise filter frequency based on local power standards (50 or 60 Hz).
Guides on comparing the magmeter calibration to an external system for verification.
Covers functions to change displayed information and output values, such as operational outputs.
Explains how to select between electronic and user calibration bases for display and output values.
Describes diagnostic displays for evaluating process stream abnormalities like electrical or flow deviations.
Details the frequency output signal and its compatibility with other instruments.
Lists compatible +GF+Signet flow instruments for frequency output.
Provides tables with calibration data for various pipe types and sizes.
Details the procedure for calculating custom K-factors using pipe ID and ft/s units.
Lists available spare parts and their corresponding codes for the magmeter.
To Next Page