enMotion
®
Recessed Automated Touchless Towel Dispenser
Installation Instructions for New and Retrofit Construction
This manual is designed to assist you in the installation of the
Georgia-Pacific enMotion Recessed Automated Touchless Towel Dispenser.
Below you will find several different application procedures. If you should
have any questions, please contact our Installation Support Team at
1-877-377-2737.
NOTE:
The following tools are necessary to properly complete this installation:
• Cordless drill and Phillips head drill bit
• Hammer
• Vise grip pliers
• Masking tape
• Sheetrock saw
• Two drift pins: one 1/32” and one 1/16” diameter
• #10 pan head self-tapping screws
Georgia-Pacific professional installation available at no cost for
20 units or more.
Georgia-Pacific makes no representations or warranties of Bobrick Washroom Equipment, Inc.
(“Bobrick”).
The installation description and illustration herein are to serve as a guide. Georgia-Pacific reserves
the right and does from time to time make changes and improvements in design, dimensions and
subsequent installation instructions. Georgia-Pacific does not take responsibility for any damage,
or injury to persons or property or any other incidental or consequential losses due to these instal-
lation instructions.
enMotion® is a registered trademark of Georgia-Pacific Corporation ©2005.
Georgia-Pacific Corporation. All rights reserved.
To Next Page
Need help?
General
