Geotech PGT 900 - Page 60

25
Main shaft is moving ,the bolts
for tightening the cover for the
rear of the gear-box body are
loose
Screw the bolts tight
Deformation of shift bar brings
about interference when you
shift
Adjust the shift bar or Replace it
Failure to shift the
reversing shift to the right
position
Abrasion of reversing fork
Re-adjust the cable of reversing shift
Replace the reversing fork
Malfunction of reversing cable
Re-adjust the cable
Replace the cable
the reversing shaft is loose
Screw the bolts tight at the back of the
reversing shaft
The reversing fork is blocked
to a standstill
Clean the combined face between
reversing fork and reversing pushing
plate to make the fork move freely
The reversing gears do
not reset
The loosening of reversing
shaft makes the gear be
Screw the bolts tight at the back of the
reversing shaft.