-Lock-out handle requiring key for access to work area.
-Digital pressure readout with low pressure alarm for work area.
-Inward/Outward face velocity is 95-100 linear feet per minute at gloveport opening, to
protect operator/product during massive breach of containment.
-Glove changes can be made without breaking containment.
-Locking casters are standard, seismic anchors are available.
Ergonomics-
-Hydraulic assist height adjusting stand offers a full 10” range variance allowing operators to
sit or stand comfortably for extended time periods.
-Stainless steel sliding tray inside the airlock pulls into the work area eliminating reaching
strains.
-Two part sleeve/glove system allows the use of most types and sizes of commercially
available gloves for better dexterity and tactility.
-Extra large oval gloveports are placed with bottoms together to provide an
athropometrically correct configuration that accommodates a wide range of body types and
increases range of movement.
-Gloveports have a 3” arm rest to reduce operator fatigue.
-Large viewing panel is at an angle to reduce glare and operator strain.
-Integrated foot rest.
Configuration Options-
-Overall work area pressure can be either positive or negative and can be altered in-place by
a certifier.
-Antechamber can be left or right handed or can be installed on both sides.
-Waste and sharps removal tubes can be left or right handed or can be installed on both
sides.
-Three available exhaust options that can be factory set or changed by a certifier in-place.
Filtration-
-Full framed standard size minipleat HEPAs filter 100% of inlet and exhaust air from both
the work area and the antechamber to provide a fully contained environment.
-HEPA filters are full coverage and front loading for easy replacement by a certifier.
-A Prefilter extends the life of the work area supply HEPA filter and can be replaced without
tools.
Electrical-
-High capacity motor/blower systems with speed control to extend HEPA filters life.
-Ten foot hospital grade power cord with molded grounded plug.
-Sealed outlet in work area.
-Separate lighted power ON/OFF indicator switches for blower and lighting.
-High efficiency, standard sized fluorescent lights are externally mounted to minimize heat
build-up.
-Voltage = 115 Volt, 60 Hz (220/50-60 Hz also available).
-Amperage Rating = 15, Running Amperage = 6
Exhaust-
-Clean air plenum is external to the work area.
-Constructed to allow for optional outside venting of exhaust air.
53
To Next Page
Loading...
