1 Important
1.1 General
The information in this Service Manual is based on
the Servo-u/Servo-n Ventilator System of System
version 4.1. Unless otherwise stated, the Service
Manual is valid also for System versions below 4.1.
Maquet Critical Care AB, part of Getinge, is the legal
manufacturer of the Servo Ventilator Systems.
Service documentation for the Servo-u/Servo-n
Ventilator System consists of:
User's Manual including Cleaning and Maintenance
manual. The User's Manual is an indispensable
complement to the Service Manual for proper
servicing.
Service Manual. Note that the Service Manual
addendum Servo-u MR is required for additional
service information regarding Servo-u MR.
Installation Instructions
Spare parts information
Documentation for optional equipment included in
the system.
Product End-of-Life - Disassembly Instructions
(Disassembly and Disposal Instructions)
The Servo-u/Servo-n Ventilator System is referred to
as 'the system' in this document.
The User's Manual for the Servo-u/Servo-n Ventilator
System is referred to as 'the User's Manual' in this
document.
Maquet Headquarter Support Center is referred to as
‘MCC HSC’ in this document. Note that MCC HSC is
available only for the Getinge service organization.
For other service organizations, for example hospital
biomedical departments, technical support is provided
by the local Getinge representative.
In addition to the Important information given here and
in the related documents, always pay attention to
applicable local and national regulations.
Responsibility for the safe functioning of the equipment
reverts to the owner or user in all cases in which
service or repair has been done by a non-professional
or by persons who are not employed by or authorized
by Getinge, and when the equipment is used for other
than its intended purpose.
The system complies with standards and requirements
as stated in the User's Manual.
WARNING! Do not modify this
equipment without authorization of the
manufacturer.
System version and System software version
The System version number can be found in the
SYSTEM STATUS window on the User interface.
Make sure that the version of the User’s Manual
corresponds to the System version.
The System SW version number can be found in the
SYSTEM STATUS window on the User interface. For
functionality enhancement, the latest released System
SW version is always recommended.
Serial number
There are two serial number labels on the unit:
One label is attached to the Patient unit. The serial
number stated on this label is the ID number of the
Patient unit. The serial number is also stored in the
software memory as the 'System ID'.
One label is attached to the rear side of the User
interface. The serial number stated on this label is
the ID number of the User interface.
Servo-u/Servo-n Ventilator System, Service Manual
1 - 1
| Important |
1 |
To Next Page
Loading...
