GF MSA 330 - Language and Calendar Settings

3 Configuration settings Operating Manual MSA 330 / MSA 340
18
(*)
(*) Visible only with administrator rights.
3.1 Language
The LANGUAGE item, allows to choose the language of the messages
displayed by the machine as well as the language used in the welding
protocol reports.
LANGUAGE
IT
Esc OK
Select by ()() the desired language and push START/OK ( I ) to
confirm the setting. To cancel the operation press STOP/ESC (O).
3.2 Calendar
The DATE/TIME menu allows to set the calendar; date and time are
shown in the format:
Day / Month / Year hour : minutes
DATE/TIME
D
D.MM.YY HH:MM
Esc OK
Select by ()() the desired value; move the cursor position by ()()
to continue the insertion. When insertion is completed, press
START/OK ( I ) to confirm the setting. To cancel instead the operation
press STOP/ESC (O).
3.3 Fusion mode
The FUSION MODE menu defines the input mode of the fusion
parameters.
FUSION MODE
Barcode input
Esc OK
ADDITIONAL CONFIG.