Need help?Do you have a question about the GF MSE 63 and is the answer not in the manual?
The MSE 63 unit is used for welding PE, PP and PVDF pipes and fittings up to 63mm diameter.
The welding process involves inserting pipe into fitting and heating without filler material.
Clean pipe and fitting with alcohol before making the joint.
Use holding devices and check unit for good working order and bushing integrity.
Connect to power, set temperature. Green LED flashes when set point is reached.
Connect to power, set temperature. Red LED flashes when set point is reached.
Wait approximately 10 minutes after reaching set temperature for proper heat distribution.
Insert pipe and fitting axially into bushings, hold for specified time, then slide together.
Allow welded areas to cool down completely, approximately one hour.
Adhere to safety rules regarding power supply, wet hands, cable handling, and authorized personnel.
Avoid flammable substances, keep unit clean, store properly, and use in suitable environments.
Unplug and cool before maintenance, use qualified personnel for repairs, and use original spare parts.
Specifies welding diameter range (16-63mm) and compatible pipe/fitting materials (PE, PP, PVDF).
Details voltage, power consumption, and temperature tolerance for thermostatic and electronic versions.
Provides the weight and dimensions of the product's carton box.
To Next Page
General