Gigabyte AORUS MASTER Z490 - Page 12

- 12 -
Hardware Installation
Back Panel
Connectors
 1 x Q-Flash Plus button
 1 x Clear CMOS button
 2 x SMA antenna connectors (2T2R)
 1 x HDMI port
 1 x USB Type-C
™
port, with USB 3.2 Gen 2 support
 3 x USB 3.2 Gen 2 Type-A ports (red)
 2 x USB 3.2 Gen 1 ports
 4 x USB 2.0/1.1 ports
 1 x RJ-45 port
 1 x optical S/PDIF Out connector
 5 x audio jacks
I/O Controller  iTE
®
I/O Controller Chip
Hardware
Monitor
 Voltage detection
 Temperature detection
 Fan speed detection
 Watercoolingowratedetection
 Overheating warning
 Fan fail warning
 Fan speed control
* Whether the fan (pump) speed control function is supported will depend on the fan
(pump) you install.
 Noise detection
BIOS  2x256Mbitash
 Use of licensed AMI UEFI BIOS
 Support for DualBIOS
™
 PnP 1.0a, DMI 2.7, WfM 2.0, SM BIOS 2.7, ACPI 5.0
Unique Features  Support for APP Center
* Available applications in APP Center may vary by motherboard model. Supported
functionsofeachapplicationmayalsovarydependingonmotherboardspecications.
- @BIOS
- EasyTune
- Fast Boot
- Game Boost
- RGB Fusion
- Smart Backup
- System Information Viewer
- USB TurboCharger
 Support for Q-Flash Plus
 Support for Q-Flash
 Support for Xpress Install