Gigabyte G1.Sniper 5 - Page 21

- 21 -
Hardware Installation
After installing the DisplayPort device, make sure the default device for sound playback is the
DisplayPortdevice.(Theitemnamemaydifferfromoperatingsystem.RefertotheHDMIsettings
informationonthepreviouspageforthecongurationdialogbox.)
RJ-45 LAN Port (LAN2)
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
Activity LED
Connection/
Speed LED
LAN Port
Activity LED:Connection/Speed LED:
State Description
Orange 1 Gbps data rate
Green 100 Mbps data rate
Off 10 Mbps data rate
State Description
Blinking Data transmission or receiving is occurring
On No data transmission or receiving is
occurring
RJ-45 LAN Port (LAN1)
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
Line In/Mic In Jack
The line in/Mic in jack. Use this audio jack for line in devices such as optical drive, walkman, microphone, etc.
Line In
The default line out jack. Use this audio jack for a 2-channel speaker. This jack can be used to connect
frontspeakersina5.1-channelaudioconguration.
Optical S/PDIF Out Connector
This connector provides digital audio out to an external audio system that supports digital optical audio.
Before using this feature, ensure that your audio system provides an optical digital audio in connector.
Center/Subwoofer Speaker Out Jack
Usethisaudiojacktoconnectcenter/subwooferspeakersina5.1-channelaudioconguration.
Rear Speaker Out
Usethisaudiojacktoconnectrearspeakersina5.1-channelaudioconguration.
Headphone/Speaker Out Jack
This audio output jack supports audio amplifying function. For better sound quality, it is recommended that
you connect your headphone/speaker to this jack.
Refertotheinstructionsonsettingupa2/5.1-channelaudiocongurationinChapter6,"Conguring
2/5.1-Channel Audio."
TripleDisplayCongurationsfortheOnboardGraphics:
Triple-displaycongurationsaresupportedafteryouinstallmotherboarddriversinOS.Onlydual-display
congurationsaresupportedduringtheBIOSSetuporPOSTprocess.
Activity LED
Connection/
Speed LED
LAN Port
Activity LED:Connection/Speed LED:
State Description
Orange 1 Gbps data rate
Green 100 Mbps data rate
Off 10 Mbps data rate
State Description
Blinking Data transmission or receiving is occurring
Off No data transmission or receiving is
occurring