Gigabyte G1.Sniper 5 - Page 75

- 75 -
Conguring SATA Hard Drive(s)
Figure 4
Figure 5
4. Next: After completing the settings above, move to Next and press <Enter> to begin creating the array.
When prompted to conrm whether to create this array, press <Y> to conrm or <N> to cancel (Figure 5).
To further congure the RAID array, use the up or down arrow key to move the selection bar to select an item in
the right block of the screen and press <Enter> to display options (Figure 4). Set the required items in sequence.
Steps:
1. RAID Level: Select a RAID level.
2. Stripe Size: Select the stripe block size. Options include 32 KB and 64 KB.
3. Name: Enter an array name with 1~10 letters (letters cannot be special characters).
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Congure -
>
Select free disksCreate Virtual Disk
Help
Virtual disk congurations.
ENTER: Select F10: Exit/Save ESC: Return
RAID Level : RAID 0
Max Size (MB) : 931.3GB
Stripe Size : 64KB
Quick Init : Yes
Name : Default
Threshold(%) : 100
Next
HBA 0 : Marvell 0
Virtual Disks
Free Physical Disks
* HDD 0: ST95005620AS
* HDD 1: ST95005620AS
Marvell BIOS Setup (c) 2011 Marvell Technology Group Ltd.
Congure -
>
Select free disksCreate Virtual Disk
Help
Virtual disk congurations.
ENTER: Select F10: Exit/Save ESC: Return
RAID Level : RAID 0
Max Size (MB) : 931.3GB
Stripe Size : 64KB
Quick Init : Yes
Name : Default
Threshold(%) : 100
Next
HBA 0 : Marvell 0
Virtual Disks
Free Physical Disks
* HDD 0: ST95005620AS
* HDD 1: ST95005620AS
Do you want to create this virtual disk?
Yes No
Create Virtual Disk