Gigabyte G1.Sniper Z170 - Page 7

Storage Interface  Chipset:
- 1 x M.2 Socket 3 connector (Socket 3, M key, type 2242/2260/2280 SATA &
PCIe x4/x2/x1 SSD support)
- 3 x SATA Express connectors
- 6 x SATA 6Gb/s connectors
 - SupportforRAID0,RAID1,RAID5,andRAID10
 * Referto"1-8InternalConnectors,"forthesupportedcongurationswiththeM.2,
SATA Express, and SATA connectors.
USB  Chipset:
- 7 x USB 3.0/2.0 ports (3 ports on the back panel, 4 ports available through
the internal USB headers)
- 6 x USB 2.0/1.1 ports (2 ports on the back panel, 4 ports available through
the internal USB headers)
 Chipset+ASMedia
®
USB 3.1 Controller:
- 1 x USB Type-C
™
port on the back panel, with USB 3.1 support
- 1 x USB 3.1 Type-A port (red) on the back panel
Internal
Connectors
 1 x 24-pin ATX main power connector
 1 x 8-pin ATX 12V power connector
 1 x M.2 Socket 3 connector
 3 x SATA Express connectors
 6 x SATA 6Gb/s connectors
 1 x CPU fan header
 1 x water cooling fan header (CPU_OPT)
 3 x system fan headers
 1 x front panel header
 1 x front panel audio header
 1 x S/PDIF Out header
 2 x USB 3.0/2.0 headers
 2 x USB 2.0/1.1 headers
 1 x Trusted Platform Module (TPM) header
 1 x Thunderbolt
™
add-in card connector
 1 x serial port header
 1 x parallel port header
 1 x Clear CMOS jumper
Back Panel
Connectors
 1 x PS/2 keyboard/mouse port
 1 x D-Sub port
 1 x DVI-D port
 1 x HDMI port
 1 x USB Type-C
™
port, with USB 3.1 support
 1 x USB 3.1 Type-A port (red)
 3 x USB 3.0/2.0 ports
 2 x USB 2.0/1.1 ports
 1xRJ-45port
 6xaudiojacks(Center/SubwooferSpeakerOut,RearSpeakerOut,SideSpeaker
Out, Line In, Line Out, Mic In)
I/O Controller  iTE
®
I/O Controller Chip
- 7 -