Gigabyte G1.Sniper Z97 - Page 41

- 41 -
BIOS Setup
(Note) ThisitemispresentonlywhenyouinstallaCPUandamemorymodulethatsupportthisfeature.
& ExtremeMemoryProle(X.M.P.)
(Note)
, System Memory Multiplier, Memory Frequency(MHz)
The settings above are synchronous to those under the same items on the Advanced Frequency Settings
menu.
& MemoryOverclockingProles
(Note)
 Allowsyoutosetthememoryfrequency.Optionsmayvarydependingonthememorybeingused.(Default:
Disabled)
& Memory Boot Mode
(Note)
Provides memory detection and training methods.
Auto    LetstheBIOSautomaticallycongurethissetting.(Default)
EnableFastBoot Skipmemorydetectionandtraininginsomespeciccriteriaforfastermemory
boot.
Disable Fast Boot Detect and train memory at every single boot.
& Memory Enhancement Settings
 Providesthreedifferentmemoryperformanceenhancementsettings:Normal(basicperformance),Enhanced
Stability,andEnhancedPerformance.(Default:Normal)
& Memory Timing Mode
Manual and Advanced Manual allows the Channel Interleaving, Rank Interleaving, and memory timing
settingsbelowtobecongurable.Optionsare:Auto(default),Manual,AdvancedManual.
& ProleDDRVoltage
Whenusinganon-XMPmemorymodule or ExtremeMemoryProle(X.M.P.) is set to Disabled , the value
isdisplayedaccording toyourmemoryspecication.WhenExtreme MemoryProle(X.M.P.)isset to
Prole1 or Prole2 ,thevalueisdisplayedaccordingtotheSPDdataontheXMPmemory.
& Channel Interleaving
Enables or disables memory channel interleaving. Enabled allows the system to simultaneously access
different channels of the memory to increase memory performance and stability. Auto lets the BIOS
automaticallycongurethissetting.(Default:Auto)
& Rank Interleaving
Enables or disables memory rank interleaving. Enabled allows the system to simultaneously access different
ranks of the memory to increase memory performance and stability. Auto lets the BIOS automatically
congurethissetting.(Default:Auto)