Gigabyte G1.Sniper - Page 94

Appendix - 94 -
3. Assign Array Disks: After a RAID mode is selected, RAID BIOS automatically assigns the two hard drives
installed as the RAID drives.
4. Set Block Size (RAID 0 only): Under the Block item, use the up or down arrow key to select the stripe
block size (Figure 6), ranging from 4 KB to 128 KB. Press <Enter>.
5. Set Array Size: Under the Size item, enter the size of the array and press <Enter>.
6. Conrm Creation:Afteralloftheitemsabovearecongured,theselectionbarautomaticallyjumpstothe
Conrm Creationitem.Press<Enter>.Whenpromptedtoconrmyourselection(Figure7),press<Y>to
conrmor<N>toabort.
Figure 6
Figure 7
[ RAID Disk Drive List ]
[ Create New RAID ] [ Hard Disk Drive List ]
Gigabyte Technology Corp. RAID Setup Utility v1.07.06
Name: GRAID
Level: 0-Stripe
Disks: Select Disk
Block: 128 KB
Size: 240 GB
 ConrmCreation
Model Name Available Type/Status

HDD0: ST3120026AS 120 GB Non-RAID

HDD1: ST3120026AS 120 GB Non-RAID
[ Help ]
[
hi
]-Switch RAID Block Size [ENTER]-Next [ESC]-Abort
Setting Stripe Block
Select a stripe size which will be used to
divide data from/to seperate RAID members.
The following are typical values:
RAID 0-128KB
[ RAID Disk Drive List ]
[ Create New RAID ] [ Hard Disk Drive List ]
Gigabyte Technology Corp. RAID Setup Utility v1.07.06
Name: GRAID
Level: 0-Stripe
Disks: Select Disk
Block: 128 KB
Size: 240 GB
ConrmCreation
Model Name Available Type/Status

HDD0: ST3120026AS 120 GB Non-RAID

HDD1: ST3120026AS 120 GB Non-RAID
[ Help ]
[
fg
]-Switch Unit [DEL,BS]-Delete Number [ENTER]-Next [ESC]-Abort
CONFIRM RAID CREATION
ALL DATA ON THE SELECTED HARD DISK
WILL BE LOST WHEN EXIT WITH SAVING
Create RAID on the select HDD (Y/N) ? Y