Gigabyte G482-Z50 - Removing and Installing the GPU Fan Module

System Hardware Installation - 28 -
3-3 Removing and Installing the GPU Fan Module
Follow these instructions to remove the GPU fan module:
1. Disconnect the GPU fan module cable.
2. Loosen the two thumbnail screws securing the GPU fan module in place.
3. Lift up to remove the GPU fan module from the system.
4. Follow steps 1-3 in reverse order to re-install the GPU fan module.
1
2
2
3
Before you remove the GPU fan module:
• Make sure the system is not turned on or connected to AC power.
• Disconnect all necessary cable connections. Failure to observe these warnings could result in
personal injury or damage to the equipment.
• This section applies to G482-Z50 only.