Gigabyte G482-Z53 - Page 96

BIOS Setup - 96 -
Parameter Description
SD Dump Options
Press [Enter] for more options.

SD Conguration Mode
– Select SD Mode.
– Options available: SD Dump disabled/SD Dump Enabled. Default
setting is SD Dump disabled.
AC Power Loss Options
Press [Enter] for more options.

AC Loss Control
– Select AC Loss Control Method.
– Options available: Power Off/Power On/Last State. Default setting
is Last State.
I2C Conguration Options
Press [Enter] for more options.

I2C 0/1/2/3/4/5 Enable
– Enable or disable I2C 0/1/2/3/4/5.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
Uart Conguration Options
Press [Enter] for more options.

Uart 0 Enable
– Uart 0 has no HW FC if Uart 2 is enabled.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

Uart 1 Enable
– Uart 1 has no HW FC if Uart 3 is enabled.
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

Uart 2 Enable (no HW FC)
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

Uart 3 Enable (no HW FC)
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
ESPI Conguration Options
Press [Enter] for more options.

ESPI Enable
– Options available: Disabled/Enabled/Auto. Default setting is Auto.
eMMC Options
Press [Enter] for more options.

eMMC/SD Congure
– Options available: Disabled/SD Normal Speed/SD High Speed/SD
UHSI-SDR50/SD UHSI-DDR50/SDUHSI-SDR104/eMMC Emmc
Backward Compatibility/eMMC High Speed SDR/eMMC High
Speed DDR/eMMC HS200/eMMCHS400/eMMC HS300/Auto.
Default setting is Auto.

Driver Type
– BIOS will select MS driver for SD selections.
– Options available: AMD eMMC Driver/MS Driver/Auto. Default
setting is Auto.

D3 Cold Support
– Options available: Disabled/Enabled/Auto. Default setting is Auto.

eMMC Boot
– Options available: Disabled/Enabled/Auto. Default setting is Auto.