Gigabyte GA-78LMT-S2 - Page 23

- 23 -
Surround View
 EnablesordisablestheSurroundViewfunction.ThisoptioniscongurableonlywhenInit Display First
under Advanced BIOS Features is set to PEG and an ATI graphics card is installed. (Default: Disabled)
VGA Core Clock control
Allows you to determine whether to manually set the VGA Core clock. (Default: Auto)
VGA Core Clock(MHz)
 AllowsyoutomanuallysettheVGACoreclock.Theadjustablerangeisfrom200MHzto2000MHz.
ThisitemiscongurableonlywhentheVGA Core Clock control option is set to Manual.
CPU Clock Ratio
 AllowsyoutoaltertheclockratiofortheinstalledCPU.TheadjustablerangeisdependentontheCPU
being used.
CPU NorthBridge Freq.
 AllowsyoutoaltertheNorthBridgecontrollerfrequencyfortheinstalledCPU.Theadjustablerangeis
dependent on the CPU being used.
Core Performance Boost
(Note)
Allows you to determine whether to enable the Core Performance Boost (CPB) technology, a CPU
performance-boost technology. (Default: Enabled)
CPB Ratio
(Note)
 AllowsyoualtertheratiofortheCPB.TheadjustablerangeisdependentontheCPUbeinginstalled.
(Default: Auto)
Turbo CPB
(Note)
Allows you to determine whether to improve CPU performance. (Default: Disabled)
CPU Host Clock Control
Enables or disables the control of CPU host clock. Auto(default)allowstheBIOStoautomaticallyadjust
the CPU host frequency. Manual allows the CPU Frequency (MHz)itembelowtobecongurable.
Note: If your system fails to boot after overclocking, please wait for 20 seconds to allow for automated
system reboot, or clear the CMOS values to reset the board to default values.
CPU Frequency(MHz)
 AllowsyoutomanuallysettheCPUhostfrequency.Theadjustablerangeisfrom200MHzto500MHz.
ThisoptioniscongurableonlywhenCPU Host Clock Control is set to Manual.Important It is highly
recommendedthattheCPUfrequencybesetinaccordancewiththeCPUspecications.
PCIE Clock(MHz)
 AllowsyoutomanuallysetthePCIeclockfrequency.Theadjustablerangeisfrom100MHzto150MHz.
Auto sets the PCIe clock frequency to standard 100 MHz. (Default: Auto)
HT Link Width
Allows you to manually set the width for the HT Link between the CPU and chipset.
Auto   BIOSwillautomaticallyadjusttheHTLinkWidth.(Default)
8 bit Sets HT Link Width to 8 bit.
16 bit Sets HT Link Width to 16 bit.
HT Link Frequency
Allows you to manually set the frequency for the HT Link between the CPU and chipset.
Auto   BIOSwillautomaticallyadjusttheHTLinkFrequency.(Default)
x1~x10 Sets HT Link Frequency to x1~x10 (200 MHz~2.0 GHz).
(Note) This item is present only when you install a CPU that supports this feature.