Gigabyte GA-790FXTA-UD5 - Page 51

- 51 - BIOS Setup
OnChip SATA Port4/5 Type (AMD SB750, SATA2_4~SATA2_5 connectors)
This option is congurable only when OnChip SATA Type is set to RAID or AHCI. Congures the oper-
ating mode of the integrated SATA2_4/SATA2_5 connectors.
IDE Disables RAID for the SATA controller and congures the SATA controller to PATA
mode. (Default)
As SATA Type The mode depends on the OnChip SATA Type settings.
Onboard ESATA controller (JMicron JMB362 Chip, eSATA Connectors on the Back Panel)
Enables or disables the SATA controller integrated in the JMicron JMB362 chip. (Default: Enabled)
Onboard ESATA Mode (JMicron JMB362 Chip, eSATA Connectors on the Back Panel)
Enables or disables RAID for the SATA controller integrated in the JMicron JMB362 chip or congures
the SATA controller to AHCI mode.
IDE Disables RAID for the SATA controller and congures the SATA controller to IDE
mode.
AHCI Congures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug. (Default)
RAID Enables RAID for the SATA controller.
Onboard SATA3 controller (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Enables or disables the SATA controller integrated in the Marvell 9128 chip. (Default: Enabled)
Onboard SATA3 Mode (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Allows you to decide whether to congure the SATA controller integrated in the Marvell 9128 chip to
AHCI mode.
IDE Congures the SATA controller to IDE mode. (Default)
AHCI Congures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specication that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
GSATA RAID Conguration (Marvell 9128 Chip, GSATA3_6/7 Connectors)
Allows you to congure RAID for the Marvell 9128 SATA controller. Refer to Chapter 5, "Conguring
SATA Hard Drive(s)," for instructions on conguring a RAID array.
Onboard LAN device
CMOS Setup Utility-Copyright (C) 1984-2009 Award Software
Onboard LAN device
Onboard LAN1 Function [Enabled]
Onboard LAN1 Boot ROM [Disabled]

SMART LAN1 [Press Enter]
Onboard LAN2 Function [Enabled]
Onboard LAN2 Boot ROM [Disabled]

SMART LAN2 [Press Enter]
higf
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
Item Help
Menu Level

Onboard LAN1/LAN2 Function
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.