Gigabyte GA-7PESH1 - Page 23

- 23 -
Hardware Installation
5/6/7/8) CPU0_FAN/CPU1_FAN/SYS_FAN1/SYS_FAN2 (CPU Fan/System Fan Headers)
The motherboard has a 4-pin CPU fan header (CPU_FAN1/2), a 4-pin (FAN4) system fan headers. Most
fan headers possess a foolproof insertion design. When connecting a fan cable, be sure to connect it in
the correct orientation (the black connector wire is the ground wire). The motherboard supports CPU fan
speed control, which requires the use of a CPU fan with fan speed control design. For optimum heat dis-
sipation, it is recommended that a system fan be installed inside the chassis.
• Be sure to connect fan cables to the fan headers to prevent your CPU and system from overheat-
ing. Overheating may result in damage to the CPU or the system may hang.
• Thesefanheadersarenotcongurationjumperblocks.Donotplaceajumpercapontheheaders.
PinNo. Denition
1 GND
2 +12V
3 Sense
4 Speed Control
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
1
1
1
1
DEBUG
PORT
G.QBOFM
CPU1_FAN
CPU0_FAN
CPU0_FAN
CPU1_FAN
SYS_FAN1
SYS_FAN2
SYS_FAN1
SYS_FAN2
4) PWR_DET1 (Power management connector)
5
1
PinNo. Denition
1 SMB CLK
2 SMB DATA
3 SMB Alert
4 GND
5 3.3V Sense