Gigabyte GA-7PESH1 - Sata Configuration; Aggressive Link Power Management

- 53 - BIOS Setup
(Note) This item is will not appear when the SATA mode is set ot RAID mode.
 SATAConguration
SATA Port 0/1/2/3/4/5
(Note)
Displays the installed HDD devices information. System will automatically detect HDD type.
SATA Mode Selection
Select the on chip SATA type.
RAID Mode: When set to RAID, the SATA controllerenables both its RAID and AHCI functions. You will
be allows access the RAID setup utility at boot time.
AHCI Mode: When set to AHCI,the SATA controller enables its AHCI functionality. Then the RAID
function is disabled and cannot be access the RAID setup utility at boot time.
Options available: RAID/AHCI/Disabled. Default setting is AHCI Mode.
Aggressive Link Power Management
Enable PCH to aggressively enter link power state.
Options available: Enabled/Disabled. Default setting is Enabled.
Hot Plug (for Serial SATA Port 0/1/2/3/4/5)
Enable/Disable Hot Plug support for Serial ATA Port 0/1/2/3/4/5.
Options available: Enabled/Disabled. Default setting is Disabled.
External SATA (for Serial SATA Port 0/1/2/3/4/5)
Enable/Disable External SATA support for Serial ATA Port 0/1/2/3/4/5.
Options available: Enabled/Disabled. Default setting is Disabled.
SATA Device Type (for Serial SATA Port 0/1)
DenetheSATADeviceforSerialATAPort0/1.
Options available: Hard Disk Drive/Solid State Drive. Default setting is Disabled.
Straggered Spin Up (for Serial SATA Port 0/1/2/3/4/5)
On an edge detect from 0 to 1, the PCH starts a COMreset initialization to the device.
Options available: Enabled/Disabled. Default setting is Disabled.