Gigabyte GA-7PESH3 - Page 40

Hardware Installation
- 40 -
10/11) SATA_DOM0/SATA_DOM1 (SATA DOM Jumpers)
1
1
2-3 Close: PMBus connects to BMC.
(Default setting)
1-2 Close: PMBus connects to PCH.
9) PMBUS_SEL (PMBus Power Select Jumper)
1
1
CAUTION!
• If the SATA DOM power is supplied by the motherboard, set the jumper to pin 1-2.
• If the SATA DOM power is supplied by external power, set the jumper to pin 2-3.
• If a SATA type hard drive is connected to the motherboard, please ensure the jumper is closed
and set to 2-3 pins (Default setting), in order to reduce any risk of hard disk damage.
Pleaserefertothepindenitiontableinthefollowing.
PinNo. Denition
1 P5V
2 SATA_DOM_0
3 GND
PinNo. Denition
1 P5V
2 SATA_DOM_1
3 GND
For SATA_DOM0
For SATA_DOM1