Gigabyte GA-7VT600 - Page 54

- 50 -GA-7VT600(-L) Motherboard
English
))
))
)PCI/AGP Frequency (MHz)
The values depend on CPU Host Frequency(Mhz) .
))
))
)DRAM Clock (MHz)
Please set DRAM Clock according to your requirement. (Default value: Auto)
If you use DDR266 DRAM module, please set "DRAM Clock(MHz)" to "133-DDR266". If you use
DDR333 DRAM module, please set "DRAM Clock(MHz)" to "166-DDR333". If you use DDR400 DRAM
module, please set "DRAM Clock(MHz)" to "200-DDR400".
Incorrect using it may cause your system broken. For power End-User use only!
))
))
)CPU OverVoltage Control
Increase CPU voltage may get stable for Over_Clock. But it may damage to CPU when enable this
feature.
Auto Supply voltage as CPU reguired. (Default value)
+5% / +7.5% / +10% Increase voltage range as user selected.
))
))
)AGP OverVoltage Control
Increase AGP voltage may get stable for Over_Clock. But it may damage to AGP Card when enable this
feature.
Auto Supply voltage as AGP Card reguired. (Default value)
+0.1V ~ +0.3V Set AGP voltage from 1.6V~1.8V.
))
))
)DIMM OverVoltage Control
Increase DRAM voltage may get stable for Over_Clock. But it may damage to DRAM module when
enable this feature.
Auto Supply voltage as DRAM module reguired. (Default value)
+0.1V ~ +0.3V Set DIMM voltage from 2.6V~2.8V.