Gigabyte GA-870A-UD3 - Page 91

- 91 - Appendix
B. Installing Windows Vista
The procedure below assumes that only one RAID array exists in your system.
For the AMD SB850:
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation steps.
When a screen similar to that below appears (RAID hard drive will not be detected at this stage), select Load
Driver (Figure 4).
Step 2:
Insertthemotherboarddriverdisk(MethodA)ortheremovablestoragedevicesuchasUSBashdrivethat
contains the SATA RAID/AHCI driver (Method B), then specify the location of the driver (Figure 5). Note: For
usersusingaSATAopticaldrive,besuretocopythedriverlesfromthemotherboarddriverdisktoaUSB
ashdrivebeforeinstallingWindowsVista(gototheBootDrv folder and save the whole SB8xxV folder to
theUSBashdrive).ThenuseMethodBtoloadthedriver.
Method A:
Insert the motherboard driver disk into your system and browse to the following directory:
\BootDrv\SB8xxV\RAID\LH
For Windows Vista 64-bit, browse to the LH64A folder.
Method B:
Insert the USBash drive containing the driver les and browse tothe LH (for Windows Vista 32-bit) or
LH64A (for Windows Vista 64-bit) folder.
Figure 4
Figure 5