SATA Hard Drives Configurations (Intel ICH6R)- 12 -
Step 3:
If Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 20 below
will appear. Use the ARROW keys to select Intel(R) 82801FR SATA RAID Controller* and press
ENTER. Then it will begin to load the SATA driver from the floppy disk.
Figure 17
"*" If your southbridge is ICH6R, select Intel(R) 82801FR (ICH6R).
If your southbridge is ICH5R, select Intel(R) 82801ER (ICH5R).
Figure 18
If a message appears saying one or some file(s) cannot be found, please check the floppy disk
or copy the correct SATA driver again from the motherboard driver CD.
Step 4:
When the screen as shown below appears, press ENTER to continue the SATA driver installation from
the floppy disk. The driver installation will be finished in about one minute.
To Next Page
Loading...
