GA-8I915P Dual Graphic Motherboard - 10 -
English
CPU Supports the latest Intel
®
Pentium
®
4 LGA775 CPU
Supports 800/533MHz FSB
L2 cache varies with CPU
Chipset Northbridge: Intel
®
915P Express Chipset
Southbridge: Intel
®
ICH6R
Memory 2 DDR DIMM memory slots (supports up to 4GB memory)
(Note 1)
Supports 2.5V DDR DIMM
Supports dual channel DDR 400/333 DIMM
2 DDR II DIMM memory slots (supports up to 4GB memory)
(Note 1)
Supports 1.8V DDR II DIMM
Supports dual channel DDR II 600
(Note 2)
/533/400 DIMM
(Note: Mixed mode, populating DDR and DDR II memory modules
simultaneously is not supported.)
Slots 2 PCI Express x 16 slots
1 PCI Express x 1 slot
3 PCI slots
IDE Connections 1 IDE connection (UDMA 33/ATA 66/ATA 100), allows connection of 2
IDE devices(IDE1)
2 IDE connection (UDMA 33/ATA 66/ATA 100/ATA 133), compatible with
RAID, allows connection of 4 IDE devices(IDE2,IDE3)
(Note 3)
FDD Connections 1 FDD connection, allows connection of 2 FDD devices
Onboard SATA 4 Serial ATA connections
Peripherals 1 parallel port supporting Normal/EPP/ECP mode
1 Serial port (COMA)
8 USB 2.0/1.1 ports (rear x 4, front x 4 via cable)
3 IEEE1394 ports (requires cable)
1 front audio connector
1 IR connector
1 PS/2 keyboard port
1 PS/2 mouse port
Onboard LAN Onboard Marvell 8001 chip (10/100/1000 Mbit)
1 RJ 45 port
(Note 1) Due to standard PC architecture, a certain amount of memory is reserved for system usage and
therefore the actual memory size is less than the stated amount.
For example, 4 GB of memory size will instead be shown as 3.xxGB memory during system startup.
(Note 2) To use a DDRII 600 memory module on the motherboard, you must install an 800MHz FSB
processor and overclock in BIOS.
(Note 3) Only support ATAPI mode for HDD.
1-2 Feature Summary
To Next Page
Loading...
