Gigabyte GA-8I915P Dual Graphic - 1-5 Expansion Card Installation

GA-8I915P Dual Graphic Motherboard - 16 -
English
1-5 Installation of Expansion Cards
You can install your expansion card by following the steps outlined below:
1. Read the related expansion card's instruction document before install the expansion card into the
computer.
2. Remove your computer's chassis cover, screws and slot bracket from the computer.
3. Press the expansion card firmly into expansion slot in motherboard.
4. Be sure the metal contacts on the card are indeed seated in the slot.
5. Replace the screw to secure the slot bracket of the expansion card.
6. Replace your computer's chassis cover.
7. Power on the computer, if necessary, setup BIOS utility of expansion card from BIOS.
8. Install related driver from the operating system.
Installing a PCI Express x 16 expansion card:
Please carefully pull out the small white-
drawable bar at the end of the
PCI Express x 16 slot when you try to
install/Uninstall the VGA card. Please align
the VGA card to the onboard
PCI Express x 16 slot and press firmly down
on the slot .Make sure your VGA card is
locked by the small white-drawable bar.
The GA-8I915P Dual Graphic will allow a four-monitor configuration(Quad View) when used in
conjunction with two PCI Express graphics cards that are based on identical chips and support
dual view.