Hardware Installation- 21 -
English
6) IDE (IDE Connector)
An IDE device connects to the computer via an IDE connector. One IDE connector can connect to one
IDE cable, and the single IDE cable can then connect to two IDE devices (hard drive or optical drive). If
you wish to connect two IDE devices, please set the jumper on one IDE device as Master and the other
as Slave (for information on settings, please refer to the instructions located on the IDE device).
Pin No. Definition
1 GND
2TXP
3 TXN
4 GND
5RXN
6 RXP
7 GND
1
2
3940
1
7
1
7
7) SATAII0/SATAII1/SATAII2/SATAII3 (SATA 3Gb/s Connector)
SATA 3Gb/s can provide up to 300MB/s transfer rate. Please refer to the BIOS setting for the Serial
ATA and install the proper driver in order to work properly.
To Next Page
Loading...
