BIOS Setup- 37 -
English
Onboard LAN device
Enabled Enable Onboard LAN device function. (Default value)
Disabled Disable this function.
USB Controller
Enabled Enable USB Controller. (Default value)
Disabled Disable USB Controller.
USB Legacy Support
Enabled Enable USB Legacy Support.
Disabled Disable USB Legacy Support. (Default value)
SiS Serial ATA Controller
Enabled Enable SiS Serial ATA Controller.(Default value)
Disabled Disable SiS Serial ATA Controller.
SiS Serial ATA Mode
IDE Set SiS Serial ATA Mode to IDE. (Default value)
RAID Set SiS Serial ATA Mode to RAID.
OnBoard LAN Boot ROM
This function decide whether to invoke the boot ROM of the onboard LAN chip.
Enabled Enable this function.(Default value)
Disabled Disable this function.
Onboard Serial Port 1
Auto BIOS will automatically setup the Serial port 1 address.
3F8/IRQ4 Enable onboard Serial port 1 and address is 3F8/IRQ4. (Default value)
2F8/IRQ3 Enable onboard Serial port 1 and address is 2F8/IRQ3.
3E8/IRQ4 Enable onboard Serial port 1 and address is 3E8/IRQ4.
2E8/IRQ3 Enable onboard Serial port 1 and address is 2E8/IRQ3.
Disabled Disable onboard Serial port 1.
Onboard Serial Port 2
Auto BIOS will automatically set up the Serial port 2 address.
3F8/IRQ4 Enable onboard Serial port 2 and address is 3F8/IRQ4.
2F8/IRQ3 Enable onboard Serial port 2 and address is 2F8/IRQ3. (Default value)
3E8/IRQ4 Enable onboard Serial port 2 and address is 3E8/IRQ4.
2E8/IRQ3 Enable onboard Serial port 2 and address is 2E8/IRQ3.
Disabled Disable onboard Serial port 2.
Onboard Parallel Port
Disabled Disable onboard LPT port.
378/IRQ7 Enable onboard LPT port and address is 378/IRQ7. (Default value)
278/IRQ5 Enable onboard LPT port and address is 278/IRQ5.
3BC/IRQ7 Enable onboard LPT port and address is 3BC/IRQ7.
Parallel Port Mode
SPP Use Parallel port as Standard Parallel Port.
EPP Use Parallel port as Enhanced Parallel Port.
ECP Use Parallel port as Extended Capabilities Port. (Default value)
ECP+EPP Use Parallel port as ECP & EPP mode.
To Next Page
Loading...
