GA-8S661FXM-775(rev. 2.0) Motherboard - 76 -
English
Figure 18
Figure 19
Windows Setup
S=Specify Additional Device Enter=Continue F3=Exit
Setup will load support for the following mass storage device(s):
WinXP 32bit SiS Raid/IDE Controller
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
Step 4:
When the screen as shown below appears, press ENTER to continue the SATA driver installation from
the floppy disk. The driver installation will be finished in about one minute.
Step 3:
If Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 18 below
will appear. If you want to install Windows XP(32-bit), use the ARROW keys to select WinXP 32bit SiS
Raid/IDE Controller and press ENTER. (Select Win2000 32bit SiS Raid/IDE Controller if you
want to install Windows 2000.) Then it will begin to load the SATA driver from the floppy disk.
If a message appears saying one or some file(s) cannot be found, please check the floppy
disk or copy the correct SATA driver again from the motherboard driver CD.
Windows Setup
ENTER=Select F3=Exit
to return to the previous screen.
WinXP 32bit SiS Raid/IDE Controller
Win2000 32bit SiS Raid/IDE Controller
Windows 64bit SiS Raid/IDE Controller
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
To Next Page
Loading...
