Appendix- 67 -
English
(3) Configuring RAID set in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step and proceed to Section 4 if
you do not want to create RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press <Ctrl>+<S> to enter Setup Menu or <ESC> to skip waiting" (Figure 4). Hit CTRL+S
to enter the RAID BIOS setup utility. If you cannot enter the RAID BIOS correctly, assure that your SATA
drives are properly installed.
Figure 4
Step 2:
Press CTRL+S. The SiS RAID BIOS Setting Utility - Disk Status window appears (Figure 5). To
create RAID, press R to enter the RAID Setup utility.
Figure 5
Silicon Integrated Systems Corp. RAID BIOS Setting Utility v1.05_964
(c) 2003-2005 Silicon Integrated Systems Corp. All Rights Reserved.
Press <Ctrl><S> to enter Setup Menu or <ESC> to skip waiting.
Primary Master: ST3120026AS 111GB UDMA6
Secondary Master: ST3120026AS 111GB UDMA6
SiS RAID BIOS Setting Utility
Disk Status
* Current Created Raid *
[R] : Enter Raid setup utility
[Q] : Exit current menu
Location Model Capacity Mode RAID Type
Disk 1 ST3120026AS 111GB UDMA 6 Single
Disk 2 ST3120026AS 111GB UDMA 6 Single
To Next Page
Loading...
