Gigabyte GA-8S661GXM-775 - Page 69

Appendix- 69 -
English
Step 6:
When the next message appears, press Y if you wish to proceed to map and stripe all current data and
future data to the RAID disks. Otherwise press N to perform striping on future data only. Then press
ENTER (Figure 9).
Figure 9
Figure 8
Step 5:
If RAID 0 is selected, you'll have to decide whether you want the RAID array to be created automatically
or manually (Figure 8). Press 1 to select <1> Auto Create or 2 to select <2> Manual Create. (We
recommend selecting Auto Create to most users.)
SiS RAID BIOS Setting Utility
RAID Setup
* Current Created Raid*
RAID 0
<1> Auto Create <2> Manual Create : 1
[Q] : Exit current menu
Location Model Capacity Mode RAID Type
Disk 1 ST3120026AS 111GB UDMA 6 Single
Disk 2 ST3120026AS 111GB UDMA 6 Single
SiS RAID BIOS Setting Utility
RAID Setup
* Current Created Raid *
RAID 0
Split the SOURCE (Disk 1) data to RAID disks? N
[Q] : Exit current menu
Location Model Capacity Mode RAID Type
Disk 1 ST3120026AS 111GB UDMA 6 RAID0
Disk 2 ST3120026AS 111GB UDMA 6 RAID0