GA-8S661GXM-775(rev. 2.0) Motherboard - 74 -
English
Figure 18
Figure 19
Step 4:
When the screen as shown below appears, press ENTER to continue the SATA driver installation from
the floppy disk. The driver installation will be finished in about one minute.
Step 3:
If Setup correctly recognizes the driver in the floppy disk, a controller menu similar to Figure 18 below
will appear. If you want to install Windows XP(32-bit), use the ARROW keys to select WinXP 32bit SiS
Raid/IDE Controller and press ENTER. (Select Win2000 32bit SiS Raid/IDE Controller if you
want to install Windows 2000.) Then it will begin to load the SATA driver from the floppy disk.
If a message appears saying one or some file(s) cannot be found, please check the floppy
disk or copy the correct SATA driver again from the motherboard driver CD.
Windows Setup
ENTER=Select F3=Exit
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
WinXP 32bit SiS Raid/IDE Controller
Win2000 32bit SiS Raid/IDE Controller
Windows 64bit SiS Raid/IDE Controller
Windows Setup
S=Specify Additional Device ENTER=Continue F3=Exit
Setup will load support for the following mass storage device(s):
WinXP 32bit SiS Raid/IDE Controller
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
To Next Page
Loading...
