1-6 Back Panel Connectors
о
©
ВНё
ЖНБ
о
о
ш
к
о PS/2 Keyboard and PS/2 Mouse Port
Use the upper port (green) to connect a PS/2 mouse and the lower port (purple) to connect a PS/2
keyboard.
© Parallel Port
Use the parallel port to connect devices such as a printer, scanner and etc. The parallel port is also
called a printer port.
© Serial Port
Use the serial port to connect devices such as a mouse, modem or other peripherals.
© D-Sub Port
The D-Sub port supports a 15-pin D-Sub connector. Connect a monitor that supports D-Sub
connection to this port.
© USB Port
The USB port supports the USB 2.0/1.1 specification. Use this port for USB devices such as an
USB keyboard/mouse, USB printer, USB flash drive and etc.
© RJ-45 LAN Port ®
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following
describes the states of the LAN port LEDs.
Connection/
Speed LED Activity LED Connection/Speed LED: Activity LED:
сЬг
1
НС—I
State
Description
Orange 1 Gpbs data rate
Green
100 Mpbs data rate
Off 10 Mpbs data rate
State
Description
Blinking
Data transmission or receiving is occurring
Off No data transmission or receiving is occurring
• When removing the cable connected to a back panel connector, first remove the cable
from your device and then remove it from the motherboard.
caution
e remov
j
n
g cable, pull it straight out from the connector. Do not rock it side to side
to prevent an electrical short inside the cable connector.
® Only for GA-945GCM-S2L.
- 19 -
Hardware Installation
To Next Page
Loading...
