6) IDE (IDE Connector)
The IDE connector supports up to two IDE devices such as hard drives and optical drives. Before
attaching the IDE cable, locate the foolproof groove on the connector. If you wish to connect two IDE
devices, remember to set the jumpers and the cabling according to the role of the IDE devices (for
example, master or slave). (For information about configuring master/slave settings for the IDE
devices, read the instructions from the device manufacturers.)
7) SATAIIO/1/2/3 (SATA 3Gb/s Connectors, Controlled by ICH7)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s
standard. Each SATA connector supports a single SATA device.
SATAII3
SATAII2
1 I LI 'J 1 SATAII1
SATAIIO
Pin
No.
Definition
1
GND
2 TXP
3
TXN
4
GND
5 RXN
6
RXP
7 GND
GA-945GCM-S2L/S2C Motherboard
- 24 -
To Next Page
Loading...
