2-3 Integrated Peripherals
On-Chip Primary PCI IDE
•• Enabled Enable onboard 1st channel IDE port. (Default value)
•• Disabled Disable onboard 1st channel IDE port.
On-Chip SATA Mode
•• Disabled Disable this function.
>• Auto BIOS will auto detect. (Default value)
•• Combined Set On-Chip SATA mode to Combined, you can use up to 4 HDDs on
the motherboard; 2 for SATA and the other for PATA.
>• Enhanced Set On-Chip SATA mode to Enhanced, the motherboard allows up to 6 HDDs
to use; 4 for SATA and the other for PATA.
•• Non-Combined Set On-Chip SATA mode to Non-Combined, SATA will be simulated to
PATA mode. Support a maximum of 4 SATA devices. PATA devices will be
ignored.
PATA IDE Set to
•• Ch.O Master/Slave Set PATA IDE to Ch. 0 Master/Slave. (Default value)
•• Ch,1 Master/Slave Set PATA IDE to Ch. 1 Master/Slave.
SATA Port 0/2 Set to
•• This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
If PATA IDE were set to Ch. 1 Master/Slave, this function will auto set to Ch. 0 Master/Slave.
SATA Port 1/3 Set to
•• This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
If PATA IDE were set to Ch. 0 Master/Slave, this function will auto set to Ch. 1 Master/Slave.
USB Controller
•> Enabled Enable USB controller. (Default value)
•• Disabled Disable USB controller.
CMOS Setup Utility-Copyright (C) 1984-2007 Award Software
Integrated Peripherals
On-Qhip Primary PCI IDE [Enabled] I Iteir
On-Chip SATA Mode [Auto] \ Menu Level»
M
SATA Port i .'-Set to C' 2 M «ter Slave
s \TA Pti I I 3 Sol to i'h. i M >ter state
USB Controller [Enabled]
BSB2':tt Controller [Enabled]
USB Keyboard Support [Disabled]
USB Mouse Support [Disabled]
Legacy USB storage detect [Enabled]
•) A'za!ia\Ćodec [Anto']
Onboard H/W LAN "' . •': [Enabled]
• SMART LAN [Press Enter]
-','. Onboard LAN Boot ROM [Disabled]
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 -,: ' ' [2FS/IRQ3]
Onboard Parallel Port [378/IRQ7]
'•. Parallel Port Modę.' $ '....' , [SPP]
x EC P M..d
•
l'.j DM \
TA-»<-: Move Enter: Select
F5: Previous Values
+- PU PD: Value F10:Save
F6: Fail-Sate Defaults
ESC: Exit Fl: General Help
F7: Optimized Defaults
GA-945GCM(X)-S2 Motherboard - 38 -
To Next Page
Loading...
