BIOS Setup- 35 -
English
HDD S.M.A.R.T. Capability
This feature allows your hard disk to report read/write errors and to issue warnings when third-
party hardware monitor utility is installed.
Enabled Enable HDD S.M.A.R.T. capability.
Disabled Disable HDD S.M.A.R.T. capability. (Default value)
CPU Hyper-Threading
(Note)
Enabled Enable CPU Hyper Threading Feature. Please note that this feature is only
working for operating system with multi processors mode supported.
(Default value)
Disabled Disable CPU Hyper Threading.
Limit CPUID Max. to 3
(Note)
Enabled Limit CPUID Maximum value to 3 when use older OS like NT4.
Disabled Disables CPUID Limit for windows XP. (Default value)
No-Execute Memory Protect
(Note)
Enabled Enable No-Execute Memory Protect function. (Default value)
Disabled Disable No-Execute Memory Protect function.
CPU Enhanced Halt (C1E)
(Note)
Enabled Enable CPU Enhanced Halt (C1E) function. (Default value)
Disabled Disable CPU Enhanced Halt (C1E) function.
CPU Thermal Monitor 2 (TM2)
(Note)
Enabled Enable CPU Thermal Monitor 2 (TM2) function. (Default value)
Disabled Disable CPU Thermal Monitor 2 (TM2) function.
CPU EIST Function
(Note)
Enabled Enable CPU EIST function. (Default value)
Disabled Disable EIST function.
Virtualization Technology
(Note)
Enabled Enable Virtualization technology function. (Default value)
Disabled Disable this function.
On-Chip VGA
This item allows the user to decide when to activate the onboard VGA function.
Enable If No Ext PEG Activate the onboard VGA first only when no PCI Express VGA card is
installed. (Default value)
Always Enable
Always activate the onboard VGA first, whether or not a PCI Express card is installed. If you wish
to set up a dual view configuration, set this item to Always Enable.
On-Chip Frame Buffer Size
1MB Set on-chip frame buffer size to 1 MB.
8MB Set on-chip frame buffer size to 8 MB. (Default value)
(Note) This item will show up when you install a processor which supports this function.
To Next Page
Loading...
