Gigabyte GA-990XA-UD3 R5 - Peripherals

- 47 -
BIOS Setup
2-6 Peripherals
& Initial Display Output
SpeciestherstinitiationofthemonitordisplayfromtheinstalledPCIgraphicscardorthePCIExpress
graphics card.
PCIe1Slot SetsthePCIExpressgraphicscardonthePCIEX16slotastherstdisplay.(Default)
PCIe2Slot SetsthePCIExpressgraphicscardonthePCIEX8slotastherstdisplay.
PCIe3Slot SetsthePCIExpressgraphicscardonthePCIEX4slotastherstdisplay.
PCI1Slot  SetsthePCIgraphicscardonthePCI1slotastherstdisplay.
PCI2Slot  SetsthePCIgraphicscardonthePCI2slotastherstdisplay.
& OnChip SATA Controller
 EnablesordisablestheintegratedSATAcontrollers.(Default:Enabled)
& OnChip SATA Type (SATA3 0~SATA3 3 connectors)
 EnablesordisablesRAIDfortheSATAcontrollersintegratedintheAMDChipsetorcongurestheSATA
controllers to RAID mode.
NativeIDE  CongurestheSATAcontrollertoIDEmode.
RAID Enables RAID for the SATA controller.
AHCI   CongurestheSATAcontrollerstoAHCImode.AdvancedHostControllerInterface
(AHCI)isaninterfacespecicationthatallowsthestoragedrivertoenableadvanced
SerialATAfeaturessuchasNativeCommandQueuingandhotplug.(Default)
& OnChip SATA Port4/5 Type (SATA3 4~SATA3 5 connectors)
 ThisoptioniscongurableonlywhenOnChip SATA Type is set to RAID or AHCI.Congurestheoperating
mode of the integrated SATA3 4~SATA3 5 connectors.
As SATA Type The mode depends on the OnChip SATA Type settings.
IDE   DisablesRAIDfortheSATAcontrollerandcongurestheSATAcontrollertoIDEmode.
(Default)