Gigabyte GA-C1037UN-LA - System Information

- 19 -
& CaseOpen
Displays the detection status of the chassis intrusion detection device attached to the motherboard CI
header.Ifthesystemchassiscoverisremoved,thiseldwillshow"Yes",otherwiseitwillshow"No".To
clear the chassis intrusion status record, set ResetCaseOpenStatus to Enabled, save the settings to
the CMOS, and then restart your system.
& CPU Vcore/Dram Voltage/+5V/+12V/CPU VTT
Displays the current system voltages.
& CPU/System Temperature
Displays current CPU/system temperature.
& CPU/System FAN Speed
Displays current CPU/system fan speed.
& System Fan Speed Control
Allows you to determine whether to enable the system fan speed control function and adjust the fan speed.
Normal Allows the system fan to run at different speeds according to the system temperature. You
can adjust the fan speed with EasyTune based on your system requirements. (Default)
Silent Allows the system fan to run at slow speeds.
Manual Allows you to control the system fan speed under the Slope PWM item.
Disabled Allows the system fan to run at full speeds.
& Slope PWM
 Allowsyoutocontrolthesystemfanspeed.ThisitemiscongurableonlywhenSystem Fan Speed Control
is set to Manual. Options are: 0.75 PWM value /
o
C ~ 2.50 PWM value /
o
C.
2-3 System Information
This section provides information on your motherboard model and BIOS version. You can also select the default
language used by the BIOS and manually set the system time.
& System Language
Selects the default language used by the BIOS.
& System Date
Sets the system date. The date format is week (read-only), month, date, and year. Use <Enter> to switch
betweentheMonth,Date,andYeareldsandusethe<PageUp>or<PageDown>keytosetthedesired
value.