Gigabyte GA-C1037UN-LA - Peripherals

- 23 -
& User Password
 Allowsyoutocongureauserpassword.Press<Enter>onthisitem,typethepassword,andthenpress
<Enter>.Youwillberequestedtoconrmthepassword.Typethepasswordagainandpress<Enter>.
You must enter the administrator password (or user password) at system startup and when entering BIOS
Setup. However, the user password only allows you to make changes to certain BIOS settings but not all.
To cancel the password, press <Enter> on the password item and when requested for the password, enter
thecorrectonerst.Whenpromptedforanewpassword,press<Enter>withoutenteringanypassword.
Press<Enter>againwhenpromptedtoconrm.
2-5 Peripherals
& SATA Controller(s)
Enables or disables the integrated SATA controllers. (Default: Enabled)
& SATA Mode Selection
 AllowsyoutodecidewhethertoconguretheSATAcontrollerintegratedintheChipsettoAHCImode.
IDE  CongurestheSATAcontrollertoIDEmode.(Default)
AHCI  CongurestheSATAcontrollerstoAHCImode.AdvancedHostControllerInterface(AHCI)
isaninterfacespecicationthatallowsthestoragedrivertoenableadvancedSerialATA
features such as Native Command Queuing and hot plug.
& USB2.0 Controller
Enables or disables the integrated USB 2.0/1.1 controller. (Default: Enabled)
& Audio Controller
Enables or disables the onboard audio function. (Default: Enabled)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
& Init Display First
 Speciestherstinitiation of themonitordisplayfromtheinstalled PCIgraphicscardorthe onboard
graphics.
Auto  LetsBIOSautomaticallycongurethissetting.(Default)
IGFX  Setstheonboardgraphicsastherstdisplay.
PCI  SetsthegraphicscardonthePCIslotastherstdisplay.