Gigabyte GA-EP35C-DS3R User Manual

GA-EP35C-DS3R Motherboard - 94 -
GIGABYTE SATA2 controllers:
Step 1:
Restart your system to boot from the Windows Vista setup disk and perform standard OS installation
steps. When a screen similar to that below appears (RAID/AHCI hard drive(s) will not be detected at this
stage), select Load Driver. (Figure 12).
Figure 12
Step 2:
Specify the location where the driver is saved, such as your floppy disk (Figure 13).
Figure 13

Gigabyte GA-EP35C-DS3R Specifications

General

Brand	Gigabyte
Model	GA-EP35C-DS3R
Category	Motherboard
Language	English