Gigabyte GA-EX58-UD5 - Standard Clock Control Settings

GA-EX58-UD5P/UD5 Motherboard - 48 -
>>>>>
Standard Clock Control
Base Clock(BCLK) Control
Enables or disables the control of CPU base clock. Enabled will allow the BCLK Frequency
(Mhz)item below to be configurable. Note: If your system fails to boot after overclocking, please
wait for 20 seconds to allow for automated system reboot, or clear the CMOS values to reset the
board to default values. (Default: Disabled)
BCLK Frequency (Mhz)
Allows you to manually set the CPU base clock. The adjustable range is from 100 MHz to
1200 MHz. This item is configurable only if the Base Clock(BCLK) Control option is enabled.
Important It is highly recommended that the CPU frequency be set in accordance with the CPU
specifications.
PCI Express Frequency (Mhz)
Allows you to manually set the PCIe clock frequency. The adjustable range is from 90 MHz to
150 MHz. Auto sets the PCIe clock frequency to standard 100 MHz. (Default: Auto)
C.I.A.2
CPU Intelligent Accelerator 2 (C.I.A.2) is designed to automatically adjust CPU computing power
to maximize system performance. C.I.A.2 allows your system bus to be changed dynamically
based on CPU loading through the use of 5 preset states.
Note: System stability varies, depending on your system hardware components.
Disabled Disables the use of C.I.A.2. (Default)
Cruise Increases CPU frequency by 5% or 7% depending on CPU loading.
Sports Increases CPU frequency by 7% or 9% depending on CPU loading.
Racing Increases CPU frequency by 9% or 11% depending on CPU loading.
Turbo Increases CPU frequency by 15% or 17% depending on CPU loading.
Full Thrust Increases CPU frequency by 17% or 19% depending on CPU loading.
Warning: Before using C.I.A.2, please first verify the overclocking capability of your CPU.
As stability is highly dependent on system components, when system instability occurs after
overclocking, lower the overclocking ratio.
*******
Advanced Clock Control*******
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Advanced Clock Control
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
>>>>> Sandard Clock Control
Base Clock(BCLK) Control [Disabled]
x BCLK Frequency (Mhz) 133 MHz
PCI Express Frequency (Mhz) [Auto]
C.I.A. 2 [Disabled]
>>>>> Advanced Clock Control
CPU Clock Drive [800mV]
PCI Express Clock Drive [900mV]
CPU Clock Skew [0ps]
MCH Clock Skew [0ps]
Item Help
Menu Level