Gigabyte GA-EX58-UD5 - DDR Memory Channel Timing Settings

GA-EX58-UD5P/UD5 Motherboard - 50 -
System Memory Multiplier (SPD)
Allows you to set the system memory multiplier.Auto sets memory multiplier according to
memory SPD data. (Default: Auto)
Memory Frequency (Mhz)
The first memory frequency value is the normal operating frequency of the memory being used;
the second is the memory frequency that is automatically adjusted according to the BCLK
Frequency (Mhz) and System Memory Multiplier settings.
DRAM Timing Selectable (SPD)
Manual allows all DRAM Timing items below to be configurable.
Options are: Auto (default), Manual.
Profile DDR Voltage
When using a non-XMP memory module or Extreme Memory Profile (X.M.P.) is set to
Disabled, this item will display as 1.5V. When Extreme Memory Profile (X.M.P.) is set to
Profile1, this item will display the value based on the SPD data on the XMP memory.
Profile QPI Voltage
The value displayed here is dependent on the CPU being used.
>>>>>
Channel A/B/C Timing Settings
>>>>>
Channel A/B/C Standard Timing Control
CAS Latency Time
Options are: Auto (default), 6~16.
tRCD
Options are: Auto (default), 1~15.
tRP
Options are: Auto (default), 1~15.
tRAS
Options are: Auto (default), 1~63.
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Channel A Timing Settings
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
>>>>> Channel A Standard Timing Control
x CAS Latency Time 6 Auto
x tRCD 6 Auto
x tRP 6 Auto
x tRAS 16 Auto
>>>>> Channel A Advanced Timing Control
x tRC 22 Auto
x tRRD 4 Auto
x tWTR 4 Auto
x tWR 8 Auto
x tRFC 48 Auto
x tRTP 3 Auto
x tFAW 13 Auto
x Command Rate (CMD) 1 Auto
>>>>> Channel A Misc Timing Control
x Round Trip Latency 51 Auto
Item Help
Menu Level