GA-EX58-UD5P/UD5 Motherboard - 62 -
Controller 0 (GSATA2 0/1)/ Controller 1 (GSATA2 2/3)
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Controller 0 (GSATA2 0/1)
Item Help
Menu Level
Disk/RAID Status [Press Enter]
Smart Backup Config [Press Enter]
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
The Controller 0 (GSATA2 0/1)/Controller 1 (GSATA2 2/3) submenu allows you to check the
information of the hard drive(s) connected to the GSATA2_0~3 connectors or to configure a RAID array.
The Controller 0 (GSATA2 0/1) supports the GSATA2_0 and GSATA2_1 connectors and the Control-
ler 1 (GSATA2 2/3) supports the GSATA2_2 and GSATA2_3 connectors. After the configuration, ensure
the SATA controller driver has been installed in the operating system. You can install the Smart Backup
utility (refer to Chapter 5, "Configuring SATA Hard Drive(s)," to view the device status in the operating
system.
Smart Backup
CMOS Setup Utility-Copyright (C) 1984-2008 Award Software
Smart Backup
Item Help
Menu Level
Controller 0 (GSATA2 0/1) [Press Enter]
Controller 1 (GSATA2 2/3) [Press Enter]
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
To Next Page
Loading...
