Gigabyte GA-F2A88X-D3H - Page 49

- 49 -
BIOS Setup
` SATA Conguration
& SATA Hot Plug on PORT0~SATA Hot Plug on PORT7
Enables or disable the hot plug capability for each SATA port. (Default: Disabled)
& SATA Power on PORT0~SATA Power on PORT7
Enables or disables each SATA port. (Default: Enabled)
SB PCIe Slot Video Sets the PCI Express graphics card on the PCI Express slot controlled by the
South Bridge as the rst display.
& Integrated Graphics
Enables or disables the onboard graphics function.
Auto The BIOS will automatically enable or disable the onboard graphics depending
on the graphics card being installed. (Default)
Disabled Disables the onboard graphics.
Force Always activates the onboard graphics, whether or not a PCI Express card is
installed.
& UMA Frame Buffer Size
This item is congurable only when Integrated Graphics is set to Force. Frame buffer size is the total
amount of system memory allocated solely for the onboard graphics controller. MS-DOS, for example,
will use only this memory for display. Options are: Auto (default), 256M, 512M, 1G, 2G.
` Super IO Conguration
This section provides information on the super I/O chip and allows you to congure the serial port.
& Serial Port A
Enables or disables the onboard serial port. (Default: Enabled)
` ATA Port Information
This section provides information on the device connected to each SATA port controlled by AMD Chipset.