Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies
only to fault-tolerant arrays such as RAID 1, RAID 5, and RAID 10 arrays. To replace the old drive, make sure
to use a new drive of equal or greater capacity. The procedures below assume a new drive is added to replace
a failed drive to rebuild a RAID 1 array.
driver disk. After Then double-click the RAIDXpert2
icon on the desktop to launch the RAID utility.
Step 1:
and then click Submit to launch AMD RAIDXpert2.
Step 2:
In the Disk Devices section, left-click your mouse
twice on the newly-added hard drive.
Step 3:
On the next screen, select Assign as Global Spare
and click .
Step 4:
appears, click OK to continue.
Step 5:
During the rebuild process, you can select the array
Volumes section to check the current progress.
Step 6:
OK to
complete.
To Next Page
Loading...
