Gigabyte GA-F2A88XM-D3HP - Page 59

- 59 -
Conguring a RAID Set
First,selectaRAIDmodeandpress<Enter>.Theselectionsavailabledependonthenumberoftheharddrives
being installed. Then follow the on-screen instructions to specify the array size. You can select All available space
tousethemaximumsizeallowedorusetheupordownarrowkeytoadjustthesize(Figure11)andpress<Enter>
Figure 10
Figure 11
The selection bar will move to the Disks section on the right of the screen. Select the hard drives to be included
intheRAIDarray.Usetheupordownarrowkeytoselectaharddriveandpress<Insert>.Theselectedhard
drive will be shown in green. To use all of the hard drives, simply press <A> to select all. Then press <Enter>
and the selection bar will move to the User Input sectionontheleftbottomofthescreen.(Figure10)
AMD-RAID Array Conguration (Build: 6.1.4-00059)
RAID0: Stripe set - distributes space across disks for higher performance
Arrays
Create Array
<
h
><
i
><
f
><
g
>=Choose, <Esc>=Back
<Enter>=Select Menu Item
0-00, 79GB, Ready
1-01, 79GB, Ready
User Input
Disks
Disks: 0, 1
Type: RAID 0
Select Array Type to Create
RAID5 RAID10N
RAID0 RAID1N
RAID1 Volume
RAID10 RAIDABLE
RAID50
Available Keys
AMD-RAID Array Conguration (Build: 6.1.4-00059)
Arrays
Create Array
<PAGEUP><
h
><PAGEDOWN><
i
>=Change Size
<Enter>=Complete, <Esc>=Go Back
0-00, 79GB, Ready
1-01, 79GB, Ready
User Input
Disks
Disks: 0, 1
Type: RAID 0
Total Size: 158GB
Choose Size to Make Array
Size Chosen: All available space
DOS Size: 147GB
Exactly: 158, 892, 818, 432
Available Keys