- 29 -
Before you begin
•
•
• Motherboard driver disk.
•
•
•
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available SATA
port on the motherboard. Then connect the power connector from your power supply to the hard drive.
refer to Chapter 2, "BIOS Setup," "Integrated Peripherals."
Steps:
1.
Ensure OnChip SATA Channel is enabled under Peripherals. Set to RAID.
2.
settings and exit BIOS Setup. Refer to "C-2" for more information.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
This mode supports Windows 8 64-bit installation only.
\BootDrv\UEFI RAID Utility folder in your motherboard driver
Step:
In BIOS Setup, go to and set to Windows 8 and CSM Support to . Save the
changes and exit BIOS Setup.
Running the UEFI RAID Utility
To run the UEFI RAID utility, enter the following commands.
You can enter the commands at Shell or fsx:x
Checking Disk Information
To see the hard drive information, enter the following commands and press <Enter>. You will see CONTROLLER
LIST and DISK LIST displayed on the screen.
rcadm -M -qa
Creating a RAID Array
To create a RAID array, refer to the following examples to enter the commands and press <Enter>. When
succeeded, the message which says "created sucessfully" will appear.
Chapter 3 Appendix
To Next Page
Loading...
