EasyManua.ls Logo

Gigabyte GA-G41M-ES2H - Page 20

Gigabyte GA-G41M-ES2H
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Hardware Installation - 20 -
A. Dual Display Congurations:
This motherboard provides three display ports, DVI-D, HDMI, and D-Sub ports and supports dual-display
congurations. Note that the DVI-D+HDMI conguration only works in operating system environments.
In addition, under this conguration, the BIOS Setup and POST screens can only be output from the
HDMI port.
B. Playback of HD DVD and Blu-ray Discs:
In order to get better playback quality, when playing the HD DVD or Blu-ray discs, refer to the recommended
system requirements (or better) below.
• CPU:IntelDual-Coreprocessor
•
Memory:Two1GBDDR2800memorymoduleswithdualchannelmodeenabled
• Playbacksoftware:CyberLinkPowerDVD8.0orlater(Note:PleaseensureHard
wareAccelerationisenabled.)
• HDCPcompliantmonitor(s)
USB Port
The USB port supports the USB 2.0/1.1 specication. Use this port for USB devices such as a USB key-
board/mouse, USB printer, USB ash drive and etc.
RJ-45 LAN Port
The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following de-
scribes the states of the LAN port LEDs.
To configure 7.1-channel audio, you need connect with the port of HD Audio standard via
front panel and enable the multi-channel audio feature through the audio driver. Refer to the
instructions on setting up a 2/4/5.1/7.1-channel audio conguration in Chapter 5, "Conguring
2/4/5.1/7.1-Channel Audio."
Activity LED:
State Description
Blinking Data transmission or receiving is occurring
Off No data transmission or receiving is occurring
Connection/Speed LED:
State Description
Orange 1 Gbps data rate
Green 100 Mbps data rate
Off 10 Mbps data rate
Activity LED
Connection/
Speed LED
LAN Port
Line In Jack (Blue)
The default line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.
Line Out Jack (Green)
The default line out jack. Use this audio jack for a headphone or 2-channel speaker. This jack can be
used to connect front speakers in a 4/5.1-channel audio conguration.
Mic In Jack (Pink)
The default Mic in jack. Microphones must be connected to this jack.

Table of Contents

Related product manuals