Gigabyte GA-H61M-USB3-B3 - Page 17

- 17 -
7) SATA2 0/1/2/3 (SATA 3Gb/s Connectors, Controlled by Intel H61 Chipset)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
Please connect the L-shaped end of
the SATA cable to your SATA hard
drive.
6) GSATA3_0/1 (SATA 6Gb/s Connectors, Controlled by Marvell 88SE9172 Chip)
The SATA connector conform to SATA 6Gb/s standard and are compatible with SATA 3Gb/s and SATA
1.5Gb/s standard. Each SATA connector supports a single SATA device. The Marvell 88SE9172 chip
supports RAID 0 and RAID 1. Refer to Chapter 4, "Conguring SATA Hard Drive(s)," for instructions
on conguring a RAID array.
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Pin No. Denition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
A RAID 0 or RAID 1 conguration requires two hard drives.
17
DEBUG
PORT
G.QBOFM
GSATA3_0GSATA3_1
DEBUG
PORT
G.QBOFM
7
1
7
1
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
DEBUG
PORT
G.QBOFM
1 0
3 2