- 33 -
Internal Graphics Memory Size &
Allows you to set the onboard graphics memory size. Options are: 32M~1024M. (Default: 64M)
DVMT Total Memory Size &
Allows you to allocate the DVMT memory size of the onboard graphics. Options are: 128M, 256M, MAX.
(Default: 256M)
Legacy USB Support &
Allows USB keyboard/mouse to be used in MS-DOS. (Default: Enabled)
USB3.0 Support (Etron EJ168 USB Controller) &
Enables or disables the Etron EJ168 USB 3.0 controller. (Default: Enabled)
XHCI Hand-off &
Determines whether to enable XHCI Hand-off feature for an operating system without XHCI Hand-off
support. (Default: Enabled)
EHCI Hand-off &
Determines whether to enable EHCI Hand-off feature for an operating system without EHCI Hand-off
support. (Default: Disabled)
Port 60/64 Emulation &
Enables or disables emulation of I/O ports 64h and 60h. This should be enabled for full legacy support
for USB keyboards/mice in MS-DOS or in operating system that does not natively support USB devices.
(Default: Enabled)
USB Storage Devices &
Displays a list of connected USB mass storage devices. You can congure how each device is going to be
treated. For example, you can emulate a USB ash drive as a oppy disk drive. (Default: Auto)
MarvellATAControllerConguration `
GSATA Controller (Marvell 88SE9172 Chip, GSATA3 0/1 connector) &
Enables or disables RAID for the SATA controller integrated in the Marvell 88SE9172 chip or congures
the SATA controller to AHCI mode. The area below displays the current status of the two SATA ports.
IDE Mode Disables RAID for the SATA controller and congures the SATA controllers to IDE mode.
(Default)